Abstract Objective: To investigate the cardiovascular effects produced by transthoracic application of low-intensity pulsed ultrasound therapy (LIPUST). Methods: Three-month-old male Wistar rats (± 300 g, N=16) were randomly allocated in two groups, namely SHAM (control group, faked procedures) and UST (animals treated with LIPUST). These animals, under anesthesia, were instrumented (femoral artery and vein catheterization) for hemodynamic recordings (mean blood pressure [MBP], heart rate [HR]) and blood biochemical profile (lipids, creatine kinase-myocardial band [CK-MB]). Then, LIPUST (spatial average-temporal average [ISATA] 1-MHz, power 0.1 to 1.2 W/cm2, pulsed 2:8 ms, cycle at 30%, for three minutes) was applied to animals from the UST group, externally to their thorax. SHAM animals were equally manipulated, but without application of ultrasound energy. After the hemodynamic and biochemical measurements, animals were sacrificed, and their hearts were mounted in a Langendorff apparatus for coronary reactivity evaluation. Standard histology techniques were employed to analyze the hearts. Results: LIPUST application caused statistically significant reductions in MBP (92±4 vs. 106±1 mmHg) and HR (345±14 vs. 380±17 rpm) when compared with SHAM procedures. UST rats exhibited higher CK-MB levels (318±55 vs. 198±26 U/dL) and lower plasma triglycerides levels (38±7 vs. 70±10 mg/dL) than SHAM animals. Coronary reactivity was not significantly changed by LIPUST. Cardiac histopathology showed an increase in capillary permeability in treated animals when compared with SHAM animals. Conclusion: Noninvasive LIPUST induces significant metabolic and hemodynamic changes, including intensity-dependent bradycardia and hypotension, indicating a possible therapeutic effect for cardiac events.

RESUMO As placas de circuito impresso (PCIs) são as partes mais valiosas dos resíduos eletrônicos, pois possuem uma considerável quantidade de metais com potencial de recuperação. Processos de reciclagem com o intuito de recuperar metais de PCIs têm despertado interesse ultimamente. Contudo, uma fração destes resíduos não é completamente aproveitada e tem destino incerto, como ocorre para a fração não-metálica e o pó gerados durante os processos de recuperação de metais. O foco deste estudo foi o emprego do pó gerado nos processos de cominuição mecânica, separação granulométrica, magnética e eletrostática de PCIs controladoras e indicadoras de temperatura de câmaras frias, para obter compósitos de matriz de polipropileno (PP) com diferentes teores de pó de PCIs, 5, 10 e 20% em massa. Os materiais foram pesados, misturados, moldados por injeção e posteriormente caracterizados por ensaios de tração, dureza Shore D, espectroscopia de infravermelho, análise termogravimétrica e microscopia eletrônica de varredura. Os resultados dos ensaios de tração e dureza indicaram propriedades levemente superiores às do PP puro, exceto para a deformação na ruptura, que foi reduzido em até 2,7 vezes para a amostra com 20% de resíduo. O desenvolvimento de compósitos utilizando o pó de PCIs se mostrou viável em aplicações onde as propriedades resistência à tração, rigidez e dureza são determinantes, mesmo para um elevado teor de resíduo (20%) agregado.

ABSTRACT Printed Circuit Boards (PCBs) are the most valuable parts of e-waste because they have a considerable amount of metals with recovery potential. Recycling processes aimed at recovering metals from PCBs have aroused great interest recently. However, there is a fraction of this waste that is not utilized and has uncertain destination, e.g. the non-metallic fraction and the dust generated during metal recovery processes. The focus of this study was to employ the powder generated in the mechanical comminution, granulometric, magnetic and electrostatic separation processes of controller and temperature indicator PCBs of cold rooms to obtain polypropylene (PP) matrix composites with distinct PCBs powder content, 5, 10 and 20% in weight. The sample was collected during the mechanical comminution processes. The materials were weighed, mixed, injection molded and later characterized using tensile tests, Shore D hardness, infrared spectroscopy, thermogravimetric analysis and scanning electron microscopy. Results of the tensile and hardness tests showed properties slightly superior to pure PP, except for strain at break, which was reduced up to 2.7 times for the sample with 20% of residue. In all, the development of composites using the powder of PCBs was considered feasible for applications where tensile strength, stiffness and hardness are important, even for a large amount of residue added (20%).

The aim of this work was to evaluate mass loss in each stage of the recycling process for metal recovery from PCBs of controllers and temperature indicators of cold chambers. The stages of process consists of grinding, particle size classification, magnetic and electrostatic separation. It was analyzed 13 kg of PCBs. These PCBs were crushed and ground. The ground material were subjected to magnetic and electrostatic separator. The losses in the comminution stages were 12.69 % and are lower than those found in other related works that used mixtures of different types of PCBs, whereas in this work only one model plates were analyzed. 27.2 % absolute mass loss we reached out after particle size separation with Tyler Series with 1 mm sieve presents the higher mass losses in the whole process and this fraction was not processed as it results in PCBs powder dust that interferes negatively in the electrostatic separation. Comparing the losses in the stages of shredding of PCBs employed in temperature controllers with other studies involving PCBs from the automotive industry and from computers and cell phones, is remarkable that this type of board presents significantly greater potential to be processed for recovery of its materials.

Resumen El objetivo de la presente revisión es esclarecer los conocimientos generales de la incontinencia urinaria por deficiencia esfinteriana, su diagnóstico y opciones terapéuticas. La metodología usada para la realización de este trabajo fue revisión de literatura exploratoria y descriptiva. La incontinencia urinaria tiene impacto en la calidad de vida de las mujeres en la menopausia, y actualmente se realizan diversas opciones terapéuticas deforma mínimamente invasiva por los nuevos avances tecnológicos. El diagnóstico de la IUE se basa en la realización de manera eficaz y ordenada de un examen ginecológico completo, incluyendo procedimientos técnicos. En el tratamiento, la cirugía de slings es la más usada actualmente, concomitante con las medidas-higiénico dietéticas y las técnicas psicológicas de modificación de conductas; los parámetros de calidad de vida más afectados son la actividad sexual, la urgencia miccional y las infecciones urinarias frecuentes.

Abstract The objective of this study is to clarify the general knowledge of urinary incontinence due to sphincter deficiency, its diagnosis and therapeutic options. the methodology used to carry out this work was a review of exploratory and descriptive literature. Urinary incontinence exerts an impact on the quality of life of women during menopause, and various therapeutic options are currently performed in a minimally invasive manner due to new technological advances. The diagnosis of SUI is based on the effective and orderly performance of a complete gynecological examination, including technical procedures. In the treatment, slings surgery is the most used currently, concomitant with the hygienic dietary measures and the psychological techniques of behavior modification; The most affected quality of life parameters are sexual activity, urgency and frequent urinary tract infections.

ABSTRACT With the short period of the sowing process, we observed an increase in the seeder speed set in several soil management systems that may result in decreased soybean yield and problems with penetration resistance. We aimed to assess the penetration resistance (PR) and agronomic characteristics of soybean on soil tillage and sowing speed. The randomized block design in split plot with four replications was used. The treatments consisted of six management systems, applied to the plots: no tillage (NT), no tillage and chiseling (NTc), no tillage and cross chiseling (NTcc), conventional tillage (CT), reduced tillage (RT) and conservation tillage (CsT) and four speeds, (4.6; 5.5; 7,3 and 7.8 km h-1) applied in the subplot at the time of soybean seeding. We observed in the deep layers 0.0 – 0.10; 0.10 – 0.20 and 0.20 – 0.30 m significant effect of tillage systems on the PR of the soil. The NT system showed the highest value of PR compared to other management systems studied. In the NT should be used sowing speeds above 5.5 km h-1 to decrease the compression. Low speeds favor higher yield by improving pods per plant. Speeds in the working range (5-7 km h-1) promote higher productivity by improving the number of pods per plant, and provide better stand.

Abstract Poly (butylene adipate-co-terephthalate) - PBAT is a synthetic biodegradable polymer commonly used for plastic film production from neat polymer or nanocomposites. The PBAT is submitted to high temperatures and shear rate during its processing. In the present study, the thermo stabilisation of PBAT by the addition of two types of stabilisers was studied using a torque rheometer at 60 rpm and two levels of temperature. The stabilisers were used as master batches with a percentage of 10% by weight of additive in the PBAT. Molecular weight, torque values after 10 minutes of mixing, and absorbance at 400 nm were used to evaluate the process of stabilisation. The primary and secondary antioxidant used here had a positive effect on both processing temperatures, 180 and 200 °C. The best results indicate that the primary antioxidant could be used alone to protect PBAT against thermodegradation reactions.

São raros os estudos envolvendo o uso múltiplo de recursos naturais por populações amazônicas. Este trabalho apresenta um panorama de como os índios Deni, habitantes da região de interflúvio entre dois dos maiores afluentes de água branca da bacia amazônica, os rios Juruá e Purus, utilizam dos recursos disponíveis em seu território. Os Deni são, atualmente, índios que vivem da exploração de recursos da terra firme e de regiões alagadas. São um misto de horticultores e caçadores/coletores, que utilizam toda a sua área para a obtenção de recursos para subsistência. Como regra, deslocam periodicamente seus assentamentos, evitando o esgotamento local de recursos, e provocando a modificação local do ambiente. Esta alteração aumenta temporariamente a disponibilidade de alimento. Áreas com aldeias, pomares e roçados abandonados, por sua vez, tornam-se locais onde se concentram inúmeros recursos da flora e da fauna, posteriormente explorados. O impacto provocado por este sistema é aparentemente mínimo. Os Deni estão contextualizados na periferia de um sistema capitalista, onde a única fonte de renda para adquirir bens que são hoje considerados pelos índios como indispensáveis para sua sobrevivência são os recursos naturais. Estes são e continuarão sendo explorados de maneira a produzir um excedente a ser comercializado para a obtenção de uma série de produtos industrializados, independentemente das opiniões externas. É sobre este patamar que devemos avaliar a sustentabilidade do atual manejo da área.

Studies concerning the use of multiple natural resources by Amazonian indians are scarce. This work presents a portrait of how the Deni Indians, inhabitants of an area between two of the most important white-water rivers of the Amazon basin (Juruá and Purus Rivers), exploit natural resources in their territory. The Deni exploit both the upland and floodplain forests. They are a mix of horticulturalists and hunter-gatherers, using their whole territory to obtain what they need to live. As a rule, they move their settlements periodically, avoiding local resource depletion. The Deni modify the landscape at a local level, causing an increase in resource availability. Abandoned villages, fruit orchards and crops are places where floristic and faunistic resources concentrate and are systematically exploited. The impacts of such management are apparently minimal. For the Deni society natural resources are the only way to get goods for survival, but it is inserted in the periphery of a capitalist system which exploits and will continue to exploit natural resources in order to produce a surplus for the acquisition of industrialized products, independently of external judgements. This should be the starting point to evaluate sustainability in this local management system.